Table 22. Fax receive error codes (continued) Error code Error definition Solution 286 The remote machine has transmitted invalid data. The local machine has received frames with errors during an ECM reception and requested retransmission of the failed frames. The data that is resent does not correspond to the data that was requested. This is an implementation error from the remote machine. Disable ECM and reattempt the reception. 290 The remote machine has attempted to renegotiate the session mode from ECM to non-ECM between pages. This operation is not supported, and the session has been abandoned.
Reattempt the fax reception and split the document into two portions correspond- ing to the ECM and non-ECM portions. Some machines will attempt to use non- ECM for photo mode, so this may be associated with a between page encoding change to support photo mode. 291 This isn't a communication error, and it is not expected that this error will occur under non-development scenarios. Reception has failed because the local unit is unable to open a file to receive data into. May be associated with low memory, although low memory should not, by itself, produce the error. If the error persists, cycle the power on the unit.
292 The remote machine has attempted to renegotiate the encoding mode from non-JPEG to JPEG. This operation is not supported, and the session has been abandoned. Reattempt the fax reception and split the document into two portions correspond- ing to the JPEG and non-JPEG portions. Some machines will attempt to use JPEG for photo mode, so this may be associated with a between page encoding change to support photo mode. EN Troubleshooting tools 215