Contents Connections Playback Settings Tips Appendix o Example layout for Auro-3D 11.1 channel system FR FL z 3 z 3 This speaker configuration is optimized for Auro-3D playback. FHL FHR CH SHL SHR TS Power amplifier SW SR SL C FL FR 0 Set “Floor” to “5ch” and “Height Sp” to “6ch” in the menu when connecting in this configuration. ( v p. 211) Next, set “Height” - “Front Layout” to “Front Height & Center Height” and “Middle Layout” to “Surround Height & Top Surround”. ( v p. 216) FHR FHL SHR SHL C SR SL CH TS SW z 1 The Top Surround and Center Height Speaker can be connected to the Surround Back terminal instead of the Surround Back Speaker.
z 2 For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup in place of Surround Height speakers. z 3 You can connect the external power amplifier to the Height 2 or Top Surround / Center height channel instead of the Front channel. Use the “Pre- out” setting in the menu to set the channel connected to the external power amplifier. ( v p. 218) z 1 z 1 z 2 z 2 Front panel Display Rear panel 53 Remote Index