Chapter 5: Advanced Motherboard Setup SGPIO The T-SGPIO1/ T-SGPIO2 (Serial General Purpose Input/Output) headers provide a bus between the SATA controller and the backpane to provide SATA enclosure management functions. Connect the appropriate cable from the backplane to the T-SGPIO1 header to utilize SATA management functions on your system. Note: NC indicates no connection. Chassis Intrusion A Chassis Intrusion header is located at JL1. Attach the appropriate cable to inform you of a chassis intrusion. Overheat LED Connect an LED to the JOH1 header to provide warning of chassis overheating. See the table on the right for pin definitions.
Wake-On-LAN The Wake-On-LAN header is designated JWOL. See the table on the right for pin definitions. You must have a LAN card with a Wake-On-LAN connector and cable to use the Wake-On-LAN feature. Power I2C The Power System Management Bus (I 2 C) connector (JPI 2 C1) monitors the power suppply, fan and system temperatures. See the table on the right for pin definitions.
5-17 SGPIO Header Pin Definitions (T-SGPIO1/T-SGPIO2) Pin# Definition Pin # Definition 1 NC 2 Data 3 Ground 4 Data 5 Load 6 Ground 7 CLK 8 NC Chassis Intrusion Pin Definitions (JL1) Pin# Definition 1 Battery voltage 2 Intrusion signal Overheat LED Pin Definitions (JOH1) Pin# Definition 1 3.3V 2 OH Active Wake-On-LAN Pin Definitions (JWOL) Pin# Definition 1 +5V Standby 2 Ground 3 Wake-up Power I2C Pin Definitions (JPI2C) Pin# Definition 1 Clock 2 Data 3 PWR Fail 4 Ground 5 +3.3V