Chapter 6: Advanced Chassis Setup Installing an Expansion Card on the Left Side On the left side (looking from the front) of the chassis, you can install a full-height, full-width expansion card, or a double width high-end graphics processing unit (GPU). Installing a Full Height Expansion Card on the Left Side 1. Power down the system and remove the chassis cover. 2. Remove the riser card bracket from the chassis by unscrewing only those screws indicated by the screwdriver icon as illustrated in Figure 6-8. Lift the bracket with the riser card from the chassis. 3. Remove the PCI slot shield in the rear chassis bracket. 4.
Slide the expansion card into the slot on the left-side riser card and fit the expan sion card shield in the PCI opening in the rear chassis bracket. 5. Secure the expansion card shield in the rear chassis bracket. Note : If you are also installing a low profile expansion card in the center of the chassis, do it at this point. 6. Replace the riser card bracket, inserting the riser card in the expansion slot on the motherboard, replace the chassis cover and power up. Figure 6-7. Left Riser Card Bracket and Expansion Cards Full Size Expansion Card Low Profile Expansion Card or GPU Riser Card Bracket 6-9