Supermicro SuperServer 1015B-M3 — Supermicro SuperServer 1015B-M3 User's Manual PDF (Revision 1.0)

Chapter 5: Advanced Serverboard Setup Universal Serial Bus (USB) There are two Universal Serial Bus ports located on the I/O panel as well as two USB headers and two "Type "A" ports located on the serverboard. The onboard ports/headers can be used to provide front side USB access (cables not included). See the table on the right for pin defi nitions. SGPIO Headers The SGPIO (Serial General Purpose Input/Output) headers are used to communicate with an enclosure man- agement chip on the backplane. See the table on the right for pin defi ni- tions. NC = No Connection Power Supply SMBus Header A Power SMB header is located at PW4. Connect the appropriate cable here to utilize SMB on your system.

See the table on the right for pin defi nitions. Onboard Power LED An onboard Power LED header is located at JLED1. This header con- nects to the control panel header (JF1) to indicate the status of system power. See the table on the right for pin defi nitions.

5-17 Universal Serial Bus Pin Defi nitions (USB) USB0/1 USB4/5/6/7 Pin # Defi nition Pin # Defi nition 1 +5V 1 +5V 2 PO- 2 PO- 3 PO+ 3 PO+ 4 Ground 4 Ground 5 N/A 5 Key SGPIO Header Pin Defi nitions (3-SGPIO-1/3-SGPIO-2) Pin# Defi nition Pin Defi nition 1 NC 2 NC 3 Ground 4 DATA Out 5 Load 6 Ground 7 Clock 8 NC Power Supply SMB Header Pin Defi nitions (PW4) Pin# Defi nition 1 Clock 2 Data 3 PWR Fail 4 Ground 5 +3.3V Onboard PWR LED Pin Defi nitions (JLED1) Pin# Defi nition 1 VCC 2 No Connection 3 Connection to PWR LED in JF1