Supermicro 1018D-73MTF — SUPERSERVER 1018D-73MTF — User's Manual

Chapter 5: Advanced Motherboard Setup Fan Headers The X10SL7-F has five fan headers (Fan1 - Fan4 and FanA). These are all 4-pin fan headers, however pins 1-3 are backward compatible with traditional 3-pin fans. Fan speed is controlled via IPMI based on the system temperature. Refer to the table on the right for pin definitions. Note : Please use all 3-pin fans or all 4-pin fans. Do not mix 3-pin fans and 4-pin fans on the same board. Chassis Intrusion A Chassis Intrusion header is located at JL1 on the motherboard. Attach the ap­ propriate cable from the chassis to inform you of a chassis intrusion when the chas­ sis is opened.

Trusted Platform Module Header This header is used to connect a Trusted Platform Module (TPM), available sepa­ rately from a third-party vendor. A TPM is a security device that allows encryption and authentication of hard drives, disal­ lowing access if the TPM associated with it is not installed in the system. See the table on the right for pin definitions.

5-15 Fan Header Pin Definitions Pin# Definition 1 Ground (Black) 2 2.5A/+12V (Red) 3 Tachometer 4 PWM Control _ Chassis Intrusion Pin Definitions Pin# Definition 1 Intrusion Input 2 Ground Trusted Platform Module Header Pin Definitions Pin # Definition Pin # Definition 1 LCLK 2 GND 3 LFRAME 4 No Pin 5 LRESET 6 VCC5 7 LAD3 8 LAD2 9 VCC3 10 LAD1 11 LAD0 12 GND 13 RSV0 14 RSV1 15 SB3V 16 SERIRQ 17 GND 18 CLKRUN 19 LPCPD 20 RSV2