Supermicro — 2028TP-DECR-DECTR-DECFR_1.0.indb

SUPERSERVER 2028TP-DECR/DECTR/DECFR User's Manual 2-6 Checking the Serverboard Setup After you install the 2028TP-DECR/DECTR/DECFR server in the rack, you will need to open the unit to make sure the serverboard is properly installed and all the connections have been made. Before operating the SC217 chassis for the fi rst time, it is important to remove the protective fi lm covering the top of the chassis, in order to allow for proper ventilation and cooling. Removing the Chassis Cover and Protective Film (Figure 2-7) 1. Uplug the AC power cord from any external power source. 2. Remove the two screws which secure the top cover onto the chassis as shown above. 3.

Lift the top cover up and off the chassis. 4. Peel off the protective fi lm covering the top cover and the top of the chassis 5. Check that all ventilation openings on the top cover and the top of the chassis are clear and unobstructed. 6. Replace the chassis cover and reconnect the AC power cord. Caution: Except for short periods of time, do NOT operate the server without the cover in place. The chassis cover must be in place to allow proper airfl ow and prevent overheating. Figure 2-7. Accessing the Inside of the System Remove two screws 1 2 1 4 1 3 Check Ventilation Openings 1 5 2-10