Chapter 5: Advanced Motherboard Setup Figure 5-3. Installing DIMM into Slot Notch Notch To Install: Insert module vertically and press down until it snaps into place. Pay attention to the alignment notch at the bottom. Front View To Remove: Use your thumbs to gently push the release tabs near both ends of the module. This should release it from the slot. Note: Notch should align with the receptive key point on the slot. Release Tab Release Tab Top View of DDR3 Slot Note: Due to memory allocation to system devices, the amount of memory that remains available for operational use will be reduced when 4 GB of RAM is used. The reduction in memory availability is disproportional.
For Microsoft Windows users: Microsoft implemented a design change in the Win- dows XP with Service Pack 2 (SP2) and Windows Vista. This change is specifi c to the behavior of Physical Address Extension (PAE) mode which improves driver compatibility. For more information, please read the following article at Microsoft’s Knowledge Base website at: http://support.microsoft.com/kb/888137.
5-9 Possible System Memory Allocation & Availability System Device Si ze Physical Memory Remaining (-Available) (4 GB Total System Memory) Firmware Hub fl ash memory (System BIOS) 1 M B 3.99 Local APIC 4 KB 3.99 Area Reserved for the chipset 2 M B 3.99 I/O APIC (4 Kbytes) 4 KB 3.99 PCI Enumeration Area 1 256 MB 3.76 PCI Express (256 MB) 256 MB 3.51 PCI Enumeration Area 2 (if needed) -Aligned on 256-MB 512 boundary- MB 3.01 VGA Memory 16 M B 2.85 TSEG 1 M B 2.84 Memory available to OS and other applications 2.84