Supermicro 5038MD-H8TRF — Supermicro SuperServer 5038MD-H8TRF User's Manual (Revision 1.0) PDF

Chapter 4: Motherboard Connections Chapter 4 Motherboard Connections This section describes the connections on the motherboard and provides pinout definitions. Note that depending on how the system is configured, not all connections are required. The LEDs on the motherboard are also described here. A motherboard layout indicating component locations may be found in Chapter 1. Please review the safety precautions in Appendix B before installing or removing components. 4.1 Node Rear Panel Controls Power Button/LED There is an On/Off button (SW2) with integrated LED on the I/O panel of each node. The function is described in Chapter 1.

Unit Identifier Switch/UID LED Indicator A Unit Identifier (UID) switch and an LED Indicator are located on the motherboard. The UID switch is located at JUIDB1, which is next to the VGA port on the I/O panel. The UID LED (LED5) is located next to the UID switch. When you press the UID switch, the UID LED will be turned on. Press the UID switch again to turn off the LED indicator. The UID Indicator provides easy identification of a system unit that may be in need of service. Note: UID can also be triggered using IPMI on the motherboard. For more information on IPMI, please refer to the IPMI User's Guide posted on our website at http://www.supermicro.com .

4.2 Headers and Connectors Power Connectors The X10SDD-F motherboard is powered through the slide-in connection at the front of the board. No connecting cables are necessary. Data and Management Connectors Universal Serial Bus (USB) Ports There are two Universal Serial Bus 2.0 ports (USB0/1) supported by JKVM1 An additional USB 3.0 type "A" port (USB2) is located on the motherboard. Cables are not included. 43