Supermicro 5038MD-H8TRF — Supermicro SuperServer 5038MD-H8TRF User's Manual (Revision 1.0) PDF

SuperServer 5038MD-H8TRF User's Manual SATA and SAS Ports Two Serial ATA (SATA)/Serial Attached SCSI (SAS) 3.0 connectors (I-SATA0/SAS0, I-SATA1/ SAS1) are located on the motherboard. These connectors are for add-on cards (storage card). The system has two hard drives connected through the backplane of the motherboard. The default setting for the SATA/SAS connectors is for SATA drives. For SAS drives, an additional SAS storage card must be connected to the riser card on JPCIE2 and a cable must be connected from the storage card to the SATA/SAS connectors. Also adjust the J5 jumper setting. Note:

For more information on the SATA HostRAID configuration, please refer to the Intel SATA HostRAID user's guide posted on our website at http://www.supermicro.com . M.2/I-SATA Slots The motherboard contains four M.2 NGFF M-key/I-SATA connectors (JMD1-JMD4). M.2 was formerly Next Generation Form Factor (NGFF) and serves to replace mini PCI-E and mSATA. M.2 allows for a greater variety of card sizes, increased functionality, and spatial efficiency. Each connector has a pin that detects whether a SATA card or an M.2 card is connected. The JMD1 and JMD2 connectors both support PCI-E 3.0 x4. The JMD3 connector supports PCI-E 2.0 x4. Lastly, the JMD4 connector supports PCI-E 2.0 x2.

TPM/Port 80 Header A Trusted Platform Module (TPM)/Port 80 header is located at JTPM1 to provide TPM support and a Port 80 connection. A TPM is a security device that supports encryption and authentication in hard drives. It enables the motherboard to deny access if the TPM associated with the hard drive is not installed in the system. 44 Trusted Platform Module Header Pin Definitions Pin# Definition Pin# Definition 1 LCLK 2 GND 3 LFRAME# 4 5 LRESET# 6 +5V 7 LAD3 8 LAD2 9 +3.3V 10 LAD1 11 LAD0 12 GND 13 SMB CLK _ 14 SMB DAT _ 15 +3V Stdby 16 SERIRQ 17 GND 18 CLKRUN# 19 LPCPD# 20 LDRQ#