Supermicro 8048B-TRFT — SuperServer 8048B-TRFT User's Manual

SUPERSERVER 8048B-TRFT USER'S MANUAL Warning: Except for short periods of time (swapping hard drives), do not operate the server with the hard drive bays empty. Installing a Hard Drive to the Carrier 1. Remove the two screws securing the dummy drive to the drive carrier and remove the dummy drive. Place the hard drive carrier on a flat surface such as a desk, table or work bench. 2. Slide the hard drive into the carrier with the printed circuit board side facing down. 3. Carefully align the mounting holes in both the drive carrier and the hard drive. 4. Secure the hard drive to the carrier using six screws. 5. Install the drive carrier back into the chassis.

Make sure to close the drive carrier handle to lock the drive carrier in place. SATA Hard Drive 1 4 1 4 Drive Carrier Figure 6-3. Installing a Hard Drive into a Carrier 6-4