S UPER S ERVER 8060 Manual Alarm Reset Table 5-15 Alarm Reset Switch Pin Definitions (JF1) Pin 33 of JF1 provides a connec- tion for a switch to disable the system's audible alarm, which in- dicates either a chassis overheat condition, a power supply failure or a fan failure. The alarm reset switch will only disable the audible alarm; the alarm LED correspond- ing to the alarm will remain illumi- nated until corrective actions have been taken. See Table 5-15 for pin definitions and Figure 5-2 for pin locations. Fan Headers* Table 5-16 Fan Header Pin Definitions (CPU, CHASSIS and OH FANs) There are several fan headers on the S2QE6 to provide cooling for various components.
In addition to one fan header for each proces- sor, there are two overheat and four chassis fan headers. See the motherboard layout on page 5- 10 for locations. Refer to Table 5- 16 for pin definitions. Note: The maxi- * Caution: These fan headers are DC power. mum current limitation for the onboard fans is 0.35 amps for each, not to exceed 1.2 amps for any group of four fans (i.e. the four CPU fans or the four chassis fans). Serial Ports Table 5-17 Serial Port Pin Definitions (COM1, COM2) Serial connector COM1 is located below the parallel port (see Figure 5-8). COM2 is a header located on the motherboard near the mouse/keyboard port. See Table 5-17 for pin definitions.
5-18 Pin Number Definition 33 Alarm Input Pin Number Definition 1 2 3 Ground (black) +12V (red) Tachometer Pin Number Definition Pin Number Definition 1 DCD 2 DSR 3 Serial In 4 RTS 5 Serial Out 6 CTS 7 DTR 8 RI 9 Ground 10 NC