Chapter 5: Advanced Motherboard Setup ATX PS/2 Keyboard and PS/2 Mouse Ports Table 5-18 PS/2 Keyboard and Mouse Port Pin Definitions (J18) The ATX PS/2 keyboard and the PS/2 mouse are located on J18. See Table 5-18 for pin definitions. (The mouse port is above the key- board port. See Figure 5-8.) Universal Serial Bus (USB) USB0/USB1 Ports Two Universal Serial Bus connec- tors are located on U25. USB0 is the bottom connector and USB1 is the top connector. Note: USB0 is shared with pins 25, 27, 29 and 31 of JF1 (see page 5-17). Only one of these two connections may be used at one time. Ethernet Port An Ethernet port is located beside the COM2 port on the I/O backplane.
This port accepts RJ45 type cables. Two LEDs indi- cate a successful connection (yel- low) and activity (green). RJ45 Ethernet Port Wake-On-Ring Table 5-19 Wake-on-Ring Pin Definitions (WOR) The Wake-on-Ring header is des- ignated WOR. This function al- lows your computer to receive and be "woken up" by an incoming call when in the suspend state. Refer to Table 5-19 for pin defini- tions. The S2QE6 meets the PCI 2.2 standard, which provides the PME function to support WOR and WOL. You must also have a WOR card and cable to use WOR. 5-19 Pin Number Definition 1 2 3 4 5 6 Data NC Ground VCC Clock NC Pin Number Definition 1 2 Ground Wake-up