Supermicro SuperServer 8060 — Supermicro SuperServer 8060 User Manual PDF – 4U Quad Xeon Server Guide

Chapter 5: Advanced Motherboard Setup Core/Bus Ratio to use. The gen- eral rule is to divide the CPU speed by the bus speed (100 MHz for the S2QE6). If you have a 550 MHz CPU, dividing it by 100 will give you a CPU Core/BUS Ratio of 5.5. After determining the CPU Core/Bus Ratio, refer to Table 5- 22 for the correct settings of DIP Switch 1. DIP Switch 2 Only DIP Switch 1 is functional at this time. DIP Switch 2 should be left as set by the manufacturer. 5-9 Jumper Settings Explanation of Jumpers Connector Pins 3 2 1 To modify the operation of the motherboard, jumpers can be used to choose between optional set- tings.

Jumpers create shorts be- tween two pins to change the function of the connector. Pin 1 is identified with a square solder pad on the printed circuit board. See the motherboard layout pages for Jumper Cap 3 2 1 Setting Pin 1-2 short jumper locations. Front Side Bus Speed Table 5-23 Front Side Bus Speed Jumper Settings (JP1) The JP1 jumper sets the FSB speed. Since the S2QE6 only runs at a 100 MHz front side bus speed, you do not need to change this setting. Table 5-23 describes the jumper settings. * Note: The Auto setting allows the CPU to set the speed. 5-21 Jumper Position Definition OFF ON Auto 100 MHz