Supermicro SuperServer E100-9APP — Supermicro SuperServer E100-9APP User's Manual PDF (Revision 1.0a)

SuperServer E100-9APP User's Manual Universal Serial Bus (USB) Ports There are two USB 3.0 ports (USB4/5) and one USB 3.1 Type-C port (USB6) on the front I/O panel. They give complete Plug & Play and hot swapping capability. The USB interface is compliant with USB UHCI, Rev. 3.0. The USB interface supports Plug and Play, which enables you to connect or disconnect a device without turning off the system. HDMI Port The HDMI (High-Definition Multimedia Interface) port is used to display both high definition video and digital sound through an HDMI-capable display, using the same (HDMI) cable. VGA Port The onboard VGA port is located next to HDMI port on the front I/O panel.

Use this connection for VGA display. Power Button The Power Button connection is located on pins 1 and 2 of JF1. Momentarily contacting both pins will power on/off the system. This button can also be configured to function as a suspend button (with a setting in the BIOS - see Chapter 4). To turn off the power in the suspend mode, press the button for at least 4 seconds. See the table below for pin definitions.

22 Back Panel USB 3.0 Pin Definitions Pin# Definition 1 VBUS Pin# Definition 10 VBUS 2 D1-N 11 D2-N 3 D1-P 12 D2-P 4 GND 13 GND 5 Stda SSRX1-N _ 14 Stda SSRX2-N _ 6 Stda SSRX1-P _ 15 Stda SSRX2-P _ 7 GND DRAIN _ 16 GND DRAIN _ 8 Stda SSTX1-N _ 17 Stda SSTX2-N _ 9 Stda SSTX1-P _ 18 Stda SSTX2-P _ Power Button Pin Definitions (JF1) Pin# Definition 1 Signal 2 Ground