Supermicro SuperServer E100-9APP — Supermicro SuperServer E100-9APP User's Manual PDF (Revision 1.0a)

Chapter 3 E100-9APP I/O Introduction 3.2 Rear I/O DC Input Power Connector The system supports a 12VDC DC power in through a connector on the rear I/O panel. DIO D-SUB Connector The DIO D-SUB connector is an 8-bit general purpose I/O expander via the SMBus. See the table below for pin definitions. COM Ports Four Serial COM ports are located on the rear I/O plate. COM1/COM2 supports RS-232/RS- 422/RS-485 ports, and COM3/COM4 supports only a RS-232 port. See the figure below for pin definitions and tables below.

23 DIO D-SUB Connector Pin Definitions Pin# Definition Pin# Definition 1 GP P3V3 GP7 _ _ 2 GP P3V3 GP6 _ _ 3 GP P3V3 GP5 _ _ 4 GP P3V3 GP4 _ _ 5 GND 6 GP P3V3 GP3 _ _ 7 GP P3V3 GP2 _ _ 8 GP P3V3 GP1 _ _ 9 GP P3V3 GP0 _ _ RS-232 D-SUB Connector Pin Definitions Pin# Definition Pin# Definition 1 DCD 2 RXD 3 TXD 4 DTR 5 GND 6 DSR 7 RTS 8 CTS 9 RI RS-422 D-SUB Connector Pin Definitions Pin# Definition Pin# Definition 1 TX- 2 TX+ 3 RX+ 4 RX- 5 GND 6 N/A 7 N/A 8 N/A 9 N/A