Supermicro SuperServer E200-9AP — Supermicro SuperServer E200-9AP User's Manual (Revision 1.0) PDF Download

Chapter 3: Motherboard Connections 3.2 Headers and Connectors Front Panel Controls Front panel controls are connected to the JF1 header on the motherboard. The JF1 pins used are pins 1-4 and 13-16. Two four pin plugs at JF1 are cabled to one eight pin plug at the PCB connected to the chassis power button. 20 19 (Ground) NMI (Control signal) Power On LED (Control signal) Key Key (5V standby) HDD LED (Activity signal) (Vcc) NIC1 LED (Ground) NIC2 LED (Ground) (Vcc) (Vcc) OH/Fan Fail LED (Ground) (Vcc) Power Fail LED (Ground) (Vcc) (Ground) (Ground) Reset Button (Data signal) Power Button (Data signal) 2 1 Figure 3-1.

JF1 Pins Power Button The Power Button connection is located on pins 1 and 2 of JF1. Momentarily contacting both pins will power on/off the system. This button can also be configured to function as a suspend button (with a setting in the BIOS - see Chapter 7). To turn off the power when the system is in suspend mode, press the button for 4 seconds or longer. Reset Button The Reset Button connection is located on pins 3 and 4 of JF1. Attach it to a hardware reset switch on the computer case. 25 Power Button Pin Definitions (JF1) Pin# Definition 1 Signal 2 Ground Reset Button Pin Definitions (JF1) Pin# Definition 3 Reset 4 Ground