SuperStorageSystem 5029P-E1CTR12L User's Manual Chapter 3 Maintenance and Component Installation This chapter provides instructions on installing and replacing main system components. To prevent compatibility issues, only use components that match the specifications and/or part numbers given. Installation or replacement of most components require that power first be removed from the system. Please follow the procedures given in each section. 3.1 Removing Power Use the following procedure to ensure that power has been removed from the system. This step is necessary when removing or installing non hot-swap components or when replacing a non-redundant power supply. 1.
Use the operating system to power down the system. 2. After the system has completely shut-down, disconnect the AC power cord(s) from the power strip or outlet. (If your system has more than one power supply, remove the AC power cords from all power supply modules.) 3. Disconnect the power cord(s) from the power supply module(s). 3.2 Accessing the System The SC826BE1C-R802LPB features a removable top cover, which allows easy access to the inside of the chassis. Removing the Top Cover 1. Remove the two screws from the sides of the chassis cover. 2. Press both release tabs at the same time to unlock the cover. 3. Slide the cover toward the rear of the chassis. 4.
Lift the cover off the chassis. Warning : Except for short periods of time, do not operate the server without the cover in place. The chassis cover must be in place to allow for proper airflow and to prevent overheating. 24