Super Micro Computer, Inc. 7045A-WT — Super Micro 7045A-WT User Manual: Comprehensive Guide for System Integrators and Technicians

Chapter 5: Advanced Serverboard Setup Watch Dog Enable/Disable JWD controls the Watch Dog function. Watch Dog is a system monitor that can reboot the system when a software application hangs. Jumping pins 1-2 will cause WD to reset the system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the application that hangs. See the table on the right for jumper settings. Watch Dog must also be en- abled in BIOS. Note: When enabled, the user needs to write their own application software in order to disable the Watch Dog Timer. Compact Flash Master/Slave Select A Compact Flash Master (Primary)/Slave (Secondary) Select Jumper is located at JCF1.

Close this jumper to enable Com- pact Flash Card. For the Compact Flash Card or the Compact Flash Jumper (JCF1) to work properly, you will need to connect the Compact Flash Card power cable to JWF1 fi rst. Refer to the board layout below for the location. I 2 C Bus to PCI-X/ Slots Jumpers JI 2 C1 and JI 2 C2 allow you to connect the System Management Bus (I 2 C) to the PCI-X slots. The default set- ting is Disabled. Both jumpers must be set to the same setting See the table on the right for jumper settings.

5-23 Watch Dog Jumper Settings (JWD) Jumper Setting Defi nition Pins 1-2 Reset Pins 2-3 NMI Open Disabled Compact Flash Card Master/ Slave Select (JCF1) Jumper Defi nition Open Slave (Secondary) Closed Master (Primary) I2C to PCI-X Slots Jumper Settings (JI2C1/JI2C2) Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled