Supermicro SuperWorkstation 7048GR-TR — Supermicro SuperWorkstation 7048GR-TR User's Manual (Rev 1.0c) PDF Download

Chapter 5: Advanced Serverboard Setup Fan Headers There are eleven system/CPU fan headers (Fans 1~6, Fans A~D and Fan 11) on the serverboard. All these 4-pin fans headers are backward compatible with traditional 3-pin fans. However, fan speed control is available for 4-pin fans only. The fan speeds are controlled by firmware thermal management in IPMI. See the table on the right for pin definitions. Internal Speaker The Internal Speaker (SP1) provides audible indications for various beep codes. See the table on the right for pin definitions. Refer to the layout below for the location of the internal buzzer.

TPM/Port 80 Header A Trusted Platform Module/Port 80 header, located at JTPM1, provides TPM support and Port 80 connection. Use this header to enhance system performance and data security. See the table on the right for pin definitions. I-SGPIO1/2 & S-SGPIO Headers Three SGPIO (Serial Link General Purpose Input/Output) headers are provided. I-SGPIO1 supports I-SATA 0-3, I-SGPIO2 supports I-SATA 4/5. S-SGPIO is used for S-SATA 0-3. See the table on the right for pin definitions. Note: NC= No Connection 5-19 Fan Header Pin Definitions Pin# Definition 1 Ground 2 +12V 3 Tachometer 4 PWR Modulation (Available for 4-pin fans only) Internal Buzzer Pin Definition Pin# Definitions Pin 1 Pos.

(+) Beep In Pin 2 Neg. (-) Alarm Speaker TPM/Port 80 Header Pin Definitions Pin # Definition Pin # Definition 1 LCLK 2 GND 3 LFRAME# 4 5 LRESET# 6 +5V (X) 7 LAD 3 8 LAD 2 9 +3.3V 10 LAD1 11 LAD0 12 GND 13 SMB CLK4 _ 14 SMB DAT4 _ 15 +3V DUAL _ 16 SERIRQ 17 GND 18 CLKRUN# (X) 19 LPCPD# 20 LDRQ# (X) I-SGPIO1/2 & S-SGPIO Headers Pin Definitions Pin# Definition Pin Definition 1 NC 2 NC 3 Ground 4 Data 5 Load 6 Ground 7 Clock 8 NC