E165GB — Technische Informationen

SOFTWARE SOFTWARE 9.3.3. System information Using the function CTRL 4 you can have the following information about the system displayed: Sidr: = Standard type (no customer specific units) P_CHon —=Parity control is on P_CHoff — =Parity control is off 360 P. =Resolution of the initialized encoder resolution 9.3. Special functions 9.3.1. Changing the program selection The selection of program numbers via the hand terminal can be changed to the "open operating mode” by software, too. The result is that the change is possible only by using the access key (see Open operating mode). Program selection only possible when in the open operating mode.

Program selection also possible when in the limited operating mode (standard setting). (ems [ro J[ae9 (emu [ro [213] V3.0 Note: = Software status of the control. Controls with a software status below 3.0 are displayed as V0.0. Itis possible to execute an unauthorized external program selection for example by using a key switch. Example system information: 9.3.2. Switching off an external output or setting a zero point This special function allows you to switch off all outputs by using an external 24 V signal (pin 5, plug ext. program selection).

The zero point of the absolute angle encoder can also be set at any time by using a 24 V signal at pin 4, Special function activated Special function deactivated Enty Display Comments Back to standard display format: press button F. [em [4] [Stdn. P_CH off 360 V3.0 9.3.4. Changing the parity check LCTRL || OUTP |) 999 (errs |{ourr |{000 ‘There is the possibility of changing a program with or without a parity check. A change of programs without a parity check is very fast (within the | range of ms). The operation may make this necessary under certain circumstances. Note: ‘Changing the special functions is only possible when in the "open operating mode". Example:

Parity check activated (standard setting at the factory) If the battery buffering of the PG 671 is discharged (after 26 weeks, at the Entry Display [ere] a Comments earliest), the standard setting is set automatically. 7 | Funtion key plus + key switches the check on, function key plus - key switches it off. Note: ‘There is a continuous parity check of the current program during processing independent of a parity check during change of programs. 33 34