SOFTWARE 9.4.3. Changing the numerical code (programming access key) ‘The user may change the numerical key code as desired. The new code number may not be greater than 255. It is possible to change the numerical code only when in the “open” operating mode. The new code is entered as follows: SOFTWARE 9.4. Program generation and display 9.4.1. Starting routine the reports by showing ‘The hand terminal has a starting routine which following display once the unit has been switched on:
‘Vn.n indicates the version number for the software being Display Entry The inion senrad [=e] a system check After pressing a button the control automatically starts standard display with which is shown on the display for a short time. The status of the outputs 8 shown in the lower half of the display by means of dots. 6 the program number, encoder position and current for the outputs is appear after pressing any button. The status information Program number Transducer position Current output [EER] | ___Status display for the output 9.4.2. Entering the numerical code for the programming mode programs.
Any one-, two- or three-digit number code number at 255) may be selected as the code number. "0" is set as the Anexample: Comments —— ‘Numerical code has been entered. new CODE ‘The code may contain one, two or 6 new CODE, 6 three digits and may not exceed 255. ‘The new code will be displayed dis briefly: then the standard play will reappear. rt cies cae ‘Access has been given to the < programming mode. Now the standard display will CODE Yanan OK appear. If the code is erroneous, the following message will appear in the display: CODE ERROR m Enter the new code. = r the factory. Display . [prcoe 9.4.4.
Displaying the numerical code (programming access key) Since itis probable that the programmed numerical code might be forgotten, this code can be displayed for a short time by using a special function. This display can also be called up when in the "limited" operating mode. to generate or modify mode. Only after entering this code is it possible (up to a maximum value of Entry Comments ‘The entry can now be repeated. 35 ‘The numerical code will appear briefly at the top left of thedisplay.