SOFTWARE 9.4.8. Using the TEACH-IN feature to set cams (memorizing the encoder position) ‘The TEACH-IN function makes it possible to "memorize" the switching points - both "on" and “off” - simply by reading the momentary position of the encoder. SOFTWARE * 9.4.9. Using the 10-key pad to set cams Once the output has been determined the 10-key pad can be used to define the switching points for "on" and “off”. Values which are entered erroneously can be corrected using the DEL button. Program number Output numb ‘Transducer position Current output Pi Pos 15 St Teach-In mode —_Switch-on point Switch-off point Switch-on point Example: Entry 1 Switch-off point Example: .
Comments Display Fp Se ABS : Movesd the transducer packina terinto the on the output. Entry Display Comments EF JE OUmrtS r= ENTER [>=] PI Pos 156 A25 75156? ‘Theh switching point opti-_ can bebe optipoint can [exter] PI Pos 156 A25 TLEIS6 2 ‘The switch-on point has been can now centered. The transducer bbe moved into the desired posi tion for switching the output off. ENTER point can be Now the switch-off 2s ee ENTER PiPosnnn ENTER PI Pos 312 A25 mized with the “plus” or “minus’ 135 button. TLINSS 1.3127 ‘optimized using the ENTER PI Pos 312 A25 ‘The point isaanentered.
ne switch-off off points for the cam can now be defined, Defining the switch-on point jaa (three buttons in sequence to ‘enter 155). OUTPIS LU ‘The switch-on point is entered. ar ‘The switch-off point is defined at 275 (three buttons). Ass “plus” or [pr] Ours ‘The switching on and switching Td “minus” button. in the display. AlS The switch-off ‘ok as point is, entered;S the standard display format. button must be depressed again to set additional cams. The TI button must be pressed again to define further cams. 39 40