The tachometer measurement interval is set by the dttA parameter in: • rps (N = 1); • rpm (N = 60); • rph (N = 3600) • custom values (N = F Ч 10 -FdP , where F and FdP are variable parameters). If F Ч 10 -FdP the values dependent on dttA ( FrEQ , UdAC , dPro , LOR , HIR , UdO , dU ) can be less than 1 (for example, 0.25) and displayed on the display as 0. This occurs because fractional display is not supported. But in the operation of the device, values with a fractional part will be used. The dttA value affects the upper and lower limits of the FrEQ parameter. That is, the limits are recalculated in accordance with the coefficient N.
For example, the values of the FrEQ parameter lie in the range [1; 2500]. With the coefficient N = 60, the boundaries of the FrEQ parameter will be as follows: • lower limit: 1 Ч 60 = 60; • upper limit: 2500 Ч 60 = 150000. Counting results are shown on the display. Calculation units are displayed in the form of highlighting of single LEDs (see Table 6.2 for details). NOTICE 1. Rounding of the measurement results is carried out in a standard mathematical way, in a big way. That is, if in a rounded digit a digit is more than or equal to 5, then one is transferred to the next digit. If the measured value lies within 0.2 ...
0.5 Hz inclusively, then a value of 1 is transmitted via Modbus to indicate the presence of a signal. 2. If the digit capacity is not enough to display the selected number of digits after the decimal point, the device automatically shifts the number to the right. 34