Тексел ТХ01-RS — 7.3 Output settings

• specify values in Udo and dU . It is recommended that Udo , dU , the upper and lower limits do not go beyond 0 and FrEQ ; • set the desired output logic ( oUtdo ). Digital output control is disabled when oUtdo = 0. The output status is set using the oFFdo parameter. Analog output of the device (types И, У) functions as a П-controller and a recorder. The operation mode of the analog output is set using the oUtdAC parameter. When the output operates as a П-controller , the current value of the measured value is compared with the preset setpoint ( UdAC parameter) and the output signal is from 4 to 20 mA (for type И) or 0 to 10 V (for type У) proportional to the deviation.

The direct proportionality zone is set by the parameter Δ ( dPro ). The output signal is generated in accordance with the regulator characteristic set in the oUtdAC parameter, either in direct proportion (1) or inversely proportional (2) regulation law. Graphs explaining the principle of forming the control current and voltage of the П-controller for both characteristics are shown in the Figures 7.8 and 7.9 . Figure 7.8 – Generating of the output signal in the П-controller mode (output of type И) 45