62 Parameter Modbus register, HEX Allowed values Data type Notes Version of the device.
Not displayed on the digital indicator 0x0012 0 – no output; 1 – only digital output; 2 – only analog output; 3 – digital and analog outputs unsigned char Read only Commands Reset running hours counter rES.t 0x002F 1 – reset counter (YES) unsigned char Write only Restore factory settings dEFAUL 0x0030 1 – restore factory settings ( YES) unsigned char Write only Apply network settings APPLY 0x000F 1 – apply settings (YES) unsigned char Write only New parameters take effect after command APPLY or reboot Calibration The value of the code issued by the DAC to set the minimum value of the output signal 0x003B from 0 to 1023 unsigned short Read Only in calibration mode Default – 40 The value of the code issued by the DAC to set the maximum value of the output signal 0x003C from 0 to 1023 unsigned short Read Only in calibration mode Default – 1023 Displacement of the lower limit of the current output LdAC 0x003D from -1000 to 1000 signed short Write only The desired offset of the DAC code relative to the current is transmitted.
Default – 0