2. Check that the ejection lever is open. If it is closed, open it. The ejection lever is open. The ejection lever is closed. Figure 2-7 Ejection lever positions Note: Be sure not to injure your fingers on the lever. 3. Position the pocket as shown in the illustration below, and push it into the printer until it clicks into place. ➀ ➁ Insert the hooks on the four corners of the pocket into the holes indicated with the red rectangles, and move the pocket into place. Figure 2-8 Installing the pocket unit 4. Extend the stopper of the pocket unit. The attachment is now completed. Stopper Figure 2-9 Pocket unit stopper 2-6 Setup Rev. F