PMAC Product Guide If the servo update time is changed, Ix33 must be changed proportionately in the same direction to keep the same effect. For instance, if the servo update time is cut in half, from 440 µ sec to 220 µ sec, Ix33 must be cut in half to keep the same effect. Usually, this parameter is set initially using the Tuning utility in the PMAC Executive Program. It may be changed on the fly at any time to create types of adaptive control. Ix34 Motor x PID Integration Mode Range: 0 .. 1 Default: 1 Units: none This parameter controls when the position-error integrator is turned on.
If it is 1, position error integration is performed only when PMAC is not commanding a move (when desired velocity is zero). If it is 0, position error integration is performed all the time. If Ix34 is 1, it is the input to the integrator that is turned off during a commanded move, which means the output control effort of the integrator is kept constant during this period (but is generally not zero). This same action takes place whenever the total control output saturates at the Ix69 value. Usually, this parameter is set initially using the Tuning utility in the PMAC Executive Program.
When performing the feedforward tuning part of that utility, it is important to set Ix34 to 1 so the dynamic behavior of the system may be observed without integrator action. Ix34 may be changed on the fly at any time to create types of adaptive control. Ix35 Motor x PID Acceleration Feedforward Gain Range: 0 .. 8,388,607 Default: 0 Units: (Ix30*Ix08)/2 26 DAC bits/(counts/cycle 2 ) This term adds an amount to the control output proportional to the desired acceleration for motor x. It is intended to reduce tracking error due to inertial lag. If the servo update time is changed, Ix35 must be changed by the inverse square to keep the same effect.
For instance, if the servo update time is cut in half, from 440 µ sec to 220 µ sec, Ix35 must be quadrupled to keep the same effect. Usually, this parameter is set initially using the Tuning utility in the PMAC Executive Program. It may be changed on the fly at any time to create types of adaptive control. Ix68 Motor x Friction Feedforward Range: -32,768 .. 32,767 Default: 0 Units: DAC bits This parameter adds a bias term to the servo loop output of motor x that is proportional to the sign of the commanded velocity. That is, if the commanded velocity is positive, Ix68 is added to the output. If the commanded velocity is negative, Ix68 is subtracted from the output.
If the commanded velocity is zero, no value is added to or subtracted from the output. This parameter is intended primarily to help overcome errors due to mechanical friction. It can be thought of as a friction feedforward term. Because it is a feedforward term that does not utilize any feedback information, it has no direct effect on system stability. It can be used to correct the error resulting from friction, especially on turnaround, without the time constant and potential stability problems of integral gain. 120 I-Variables