omron — Ix80 Motor x Power-Up Mode

PMAC Product Guide If PMAC is commutating this motor, this correction is applied before the commutation algorithm, and so will affect the magnitude of both analog outputs. Note: This direction-sensitive bias term is independent of the constant bias introduced by Ix29 and/or Ix79. Example: Starting with a motor at rest, if Ix68 = 1600, then as soon as a commanded move in the positive direction is started, a value of +1600 (~0.5V) is added to the servo loop output. As soon as the commanded velocity goes negative, a value of -1600 is added to the output. When the commanded velocity becomes zero again, no bias is added to the servo output as a result of this term.

Ix69 Motor x Output Command (DAC) Limit Range: 0 .. 32,767 Default: 20,480 (~6.25V) Units: DAC bits This parameter defines the magnitude of the largest output that can be sent from the control loop. If a larger value is calculated, it is clipped to this number. The analog outputs on PMAC are 16-bit DACs which map a numerical range of -32,768 to +32,767 into a voltage range of -10V to +10V relative to analog ground (AGND). If using differential outputs (DAC+ and DAC-), the voltage between the two outputs is twice the voltage between an output and AGND.

(To limit the voltage between DAC+ and DAC- to 10V, Ix69 should be 16,384.) This parameter provides a torque limit in systems with current- loop amplifiers, or a velocity limit with tachometer-based amplifiers. Note that if this limit kicks in for any amount of time, the following error will start increasing. When Ix69 is actually limiting the output, the integrator in the PID loop will turn off for anti-windup protection. When using PMAC to do internal open-loop micro stepping (using its own commutation algorithms, not external V/F converters), the servo loop is writing to an internal register, not directly to the DACs. In this case, more than a +/-32K limit is allowed.

The value of Ix69 that should be used for this micro stepping is 524,287 (2 19 -1). Ix80 Motor x Power-Up Mode Range: 0 .. 3 Default: 0 Units: none This parameter controls the power-up mode for motor x. It controls whether the motor is enabled or killed on power-up/reset (P/R), and if the motor is commutated by PMAC (Ix01=1) and requires a phasing search (Ix78=0; Ix81=0), it controls which type of phasing search is done. The possible values of Ix80, and the effects they have, are: With Ix80=0 or 2, a command must be given to enable the motor.

For a PMAC-commutated motor, the $ command must be given to start up the commutation algorithms, performing the phasing search if necessary, then leaving the motor in closed-loop servo control at zero commanded velocity. I-Variables 121 0 Killed on P/R Two guess phasing search (on $ command only) 1 Enabled on P/R Two guess phasing search (automatically on P/R) 2 Killed on P/R Stepper motor phasing search (on $ command only) 3 Enabled on P/R Stepper motor phasing search (automatically on P/R)