omron — Second Word Returned (Y:$0814, Y:$08D4, etc.)

PMAC Product Guide Bit 9 (Reserved for future use) Bit 8 Phasing Search Error: This bit is set to 1 if the phasing search move for a PMAC-commutated motor has failed due to amplifier fault, overtravel limit, or lack of detected motion. It is set to 0 if the phasing search move did not fail by any of these conditions (not an absolute guarantee of a successful phasing search). Eleventh Character Returned: Bit 7 Trigger Move: This bit is set to 1 at the beginning of a jog-until-trigger or motion program move-until-trigger. It is set to 0 at the end of the move if the trigger has been found, but remains at 1 if the move ends with no trigger found.

This bit is useful to determine whether the move was successful in finding the trigger. Bit 6 Integrated Fatal Following Error: This bit is 1 if this motor has been disabled due to an integrated following error fault, as set by Ix11 and Ix63. The fatal following error bit (bit 2) will also be set in this case. Bit 6 is zero at all other times, becoming 0 again when the motor is re-enabled. Bit 5 I 2 T Amplifier Fault Error: This bit is 1 if this motor has been disabled by an integrated current fault. The amplifier fault bit (bit 3) will also be set in this case. Bit 5 is 0 at all other times, becoming 0 again when the motor is re-enabled. Bit 4 Backlash Direction Flag:

This bit is 1 if backlash has been activated in the negative direction. It is 0 otherwise. Twelfth Character Returned: Bit 3 Amplifier Fault Error: This bit is 1 if this motor has been disabled because of an amplifier fault signal, even if the amplifier fault signal has gone away, or if this motor has been disabled due to an I 2 T integrated current fault (in which case bit 5 is also set). It is 0 at all other times, becoming 0 again when the motor is re-enabled. Bit 2 Fatal Following Error:

This bit is 1 if this motor has been disabled because it exceeded its fatal following error limit (Ix11) or because it exceeded its integrated following error limit (Ix63; in which case bit 6 is also set). It is 0 at all other times, becoming 0 again when the motor is re-enabled. Bit 1 Warning Following Error: This bit is 1 if the following error for the motor exceeds its warning following error limit (Ix12). It stays at 1 if the motor is killed due to fatal following error. It is 0 at all other times, changing from 1 to 0 when the motor’s following error reduces to under the limit or if killed, is re-enabled. Bit 0 In Position: This bit is 1 when five conditions are satisfied:

the loop is closed, the desired velocity zero bit is 1 (which requires closed-loop control and no commanded move); the program timer is off (not currently executing any move, DWELL , or DELAY ), the magnitude of the following error is smaller than Ix28 and the first four conditions have been satisfied for (I7+1) consecutive scans. Examples: #1? ; Request status of Motor 1 812000804401 ; PMAC responds with 12 hex digits representing 48 bits ; The following bits are true (all others are false) ; Word 1 Bit 23: Motor Activated ; Bit 16: Integration Mode ; Bit 13: Desired Velocity Zero ; Word 2 Bit 23:

Assigned to Coordinate System ; (Bits 20-22 all 0 -- assigned to Coordinate System 1) ; Bit 14: Amplifier Enabled ; Bit 10: Home Complete ; Bit 0: In Position 146 Online Commands