omron — First Word Returned (X:$0818, X:$08D8, etc.)

PMAC Product Guide ?? Function : Report the status words of the addressed coordinate system. Scope : Coordinate-system specific Syntax : ?? This causes PMAC to report status bits of the addressed coordinate system as an ASCII hexadecimal word. PMAC returns twelve characters, representing two status words. Each character represents four status bits. The first character represents bits 20-23 of the first word; the second shows bits 16-19; and so on, to the sixth character representing bits 0-3. The seventh character represents bits 20-23 of the second word; the twelfth character represents its 0-3. The value of a bit is 1 when the condition is true; 0 when it is false.

The meanings of the individual bits are: First Word Returned (X:$0818, X:$08D8, etc.) First Character Returned: Bit 23 Z-Axis used in Feedrate Calculations: This bit is 1 if this axis is used in the vector feedrate calculations for F-based moves in the coordinate system. It is 0 if this axis is not used. See the FRAX command. Bit 22 Z-Axis Incremental Mode: This bit is 1 if this axis is in incremental mode (moves specified by distance from the last programmed point). It is 0 if this axis is in absolute mode ( moves specified by end position, not distance). See the INC and ABS commands. Bit 21 Y-Axis used in Feedrate Calculations: See bit 23 description. Bit 20 Y-Axis Incremental Mode:

See bit 22 description. Second Character Returned: Bit 19 X-Axis used in Feedrate Calculations: See bit 23 description Bit 18 X-Axis Incremental Mode: See bit 22 description. Bit 17 W-Axis used in Feedrate Calculations: See bit 23 description. Bit 16 W-Axis Incremental Mode: See bit 22 description. Third Character Returned Bit 15 V-Axis used in Feedrate Calculations: See bit 23 description. Bit 14 V-Axis Incremental Mode: See bit 22 description. Bit 13 U-Axis used in Feedrate Calculations: See bit 23 description. Bit 12 U-Axis Incremental Mode: See bit 22 description. Fourth Character Returned: Bit 11 C-Axis used in Feedrate Calculations: See bit 23 description.

Bit 10 C-Axis Incremental Mode: See bit 22 description. Bit 9 B-Axis used in Feedrate Calculations: See bit 23 description. Bit 8 B-Axis Incremental Mode: See bit 22 description. Online Commands 147