Supermicro 4021M-T2R+ / 4021M-82R+ — Supermicro 4021M-T2R+ / 4021M-82R+ Server User & Service Manual PDF

AS4021M-T2R+/4021M-82R+ User's Manual Onboard Speaker Enable/ Disable The JD1 header allows you to use either an external speaker or the in- ternal (onboard) speaker. To use the internal onboard speaker, close pins 6 and 7 with a jumper. To use an external speaker, remove the jumper and connect the speaker wires to pins 4 (+5V) and 7 (control signal). See the table on the right for settings and the table associated with the Power LED/ Keylock/Speaker connection (previ- Note: Pins 4-7 are used only for the on- board speaker. ous section) for jumper settings.

PCI-X Slot Speed Jumpers JPX1A and JPX1B on the H8DME-2/H8DM8-2 can be used to change the speed of PCI-X slots #1&2 and PCI-X slots #3&4, respectively. See the tables on the right for jumper settings. Note: JPX1A controls the speed for PCI-X slots #1 and #2. JPX1B controls the speed for PCI-X slots #3 and #4. The default setting for both is Auto. SCSI Controller Enable/ Disable (H8DM8-2 only) Jumper JPA1 is used to enable or dis- able the onboard SCSI controller. The default setting is on pins 1-2 to enable SCSI. See the table on right for jumper settings.

5-22 Onboard Speaker Enable/Disable Pin Defi nitions (JD1) Pins Defi nition 6 and 7 Jump for onboard speaker 4 and 7 Attach external speaker wires PCI-X Slot Speed Jumper Settings (JPX1A/JPX1B) Jumper Setting Defi nition Open Auto Pins 1-2 PCI-X 66 MHz Pins 2-3 PCI 66 MHz SCSI Enable/Disable Jumper Settings (JPA1) Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled