Chapter 5: Advanced Serverboard Setup SCSI Termination Enable/ Disable (H8DM8-2 only) Jumpers JPA2 and JPA3 are used to enable or disable termination for the SCSI Channel A and B connector, re- spectively. The default setting is open to enable termination. See the table on right for jumper settings. Note: In order for the SCSI drives to function properly, please do not change the default setting (enabled) set by the manufacturer.) VGA Enable/Disable JPG1 allows you to enable or disable the VGA port. The default position is on pins 1 and 2 to enable VGA. See the table on the right for jumper settings.
Compact Flash Master/Slave The JCF1 jumper allows you to assign either master or slave status a compact fl ash card installed in IDE1. See the table on the right for jumper settings. 5-23 SCSI Term. Enable/Disable Jumper Settings (JPA2, JPA3) Jumper Setting Defi nition Open Enabled Closed Disabled VGA Enable/Disable Jumper Settings (JPG1) Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled Compact Flash Master/Slave Jumper Settings (JCF1) Jumper Setting Defi nition Closed Master Open Slave