4.7 Test Run Note: For the details of each setting, Refer to Motor Data for Auto-Tuning on page 156 . For stationary Auto-Tuning for line-to-line resistance only, set T1-02 and T1-04. Starting Auto-Tuning Start-Up Programming & Operation WARNING! Sudden Movement Hazard. The drive and motor may start unexpectedly during Auto-Tuning, which could result in death or serious injury. Ensure the area surrounding the drive motor and load are clear before proceeding with Auto-Tuning. WARNING! Electrical Shock Hazard. High voltage will be supplied to the motor when stationary Auto-Tuning is performed even with the motor stopped, which could result in death or serious injury.
Do not touch the motor until Auto-Tuning has been completed. 4 NOTICE: Auto-Tuning will not function properly if a holding brake is engaged on the load. Failure to comply could result in improper operation of the drive. Ensure the motor can freely spin before beginning Auto- Tuning. NOTICE: Never perform rotational Auto-Tuning for a motor connected to a load. Failure to comply could result in improper drive operation. If rotational Auto-Tuning is performed for a motor coupled to a load, the motor constants will be inaccurate and the motor may exhibit abnormal operation. Disconnect or decouple the motor from the load. Enter the required information from the motor nameplate.
Press to proceed to the Auto-Tuning start screen. OYMC TOEP C71060622-01-OY V1000 User Manual 155 Step Display/Result Repeat Steps 1 through 5 to set the following parameters:T1-03, Motor Rated Voltage T1-04, Motor Rated CurrentT1-05, Motor Base 7. FrequencyT1-06, Motor Poles; T1-07, Motor Base Frequency ⇒ Step Display/Result After setting T1-07 as illustrated in the previous section, press 1. and confirm the display is as follows: ⇒ Press RUN to activate Auto-Tuning. flashes. 2. Note: The first digit indicates which motor is undergoing Auto-Tuning (motor 1 or motor 2). The second digit indicates the type of Auto-Tuning being performed. ⇒ 3.
Auto-Tuning finishes in approximately one to two minutes. ⇒