5.4 Fault Detection 200 OYMC TOEP C71060622-01-OY V1000 User Manual LED Operator Display Fault Name UL4 Undertorque Detection 2 The current has fallen below the minimum value set for torque detection (L6-05) for longer than the allowable time (L6-06). Cause Possible Solution Parameter settings are not appropriate for the type of load. Check the settings of parameters L6-05 and L6-06. There is a fault on the machine side. Check the load for any problems. LED Operator Display Fault Name UL5 Mechanical Weakening Detection 2 The operation conditions matched the conditions set to L6-08.
Cause Possible Solution Undertorque was detected and matched the condition of mechanical loss detection operation selection (L6-08). Check the load side for any problems. LED Operator Display Fault Name Uv1 DC Bus Undervoltage One of the following conditions occurred while the drive was stopped: • Voltage in the DC bus fell below the undervoltage detection level (L2-05). • For 200 V class: approximately 190 V (160 V for single phase drives) • For 400 V class: approximately 380 V (350 V when E1-01 is less then 400) The fault is output only if L2-01 = 0 or L2-01 = 1 and the DC bus voltage is under L1-05 for longer than L2-02. Cause Possible Solution Input power phase loss.
• The main circuit drive input power is wired incorrectly. • Correct the wiring. One of the drive input power wiring terminals is loose. • Ensure there are no loose terminals. • Apply the tightening torque specified in this manual to fasten the terminals. Refer to Wire Size on page 68 There is a problem with the voltage from the drive input power. • Check the voltage. • Correct the voltage to within range listed in drive input power specifications. The power has been interrupted. Correct the drive input power. Drive internal circuitry has become worn. • Check the maintenance time for the capacitors (U4-05). • Replace the drive if U4-05 exceeds 90%.
The drive input power transformer is not large enough and voltage drops after switching on power. Check the capacity of the drive input power transformer. Air inside the drive is too hot. Check the drive’s internal temperature. Problem with the CHARGE indicator. Replace the drive.