B.2 Parameter Table 348 OYMC TOEP C71060622-01-OY V1000 User Manual No. Name Description Range Def. Control Mode Addr. Hex Pg. V/f O LV P M L8-03 Overheat Pre-Alarm Operation Selection Sets the drive operation when an overheat alarm OH is detected. 0: Ramp to Stop using the active decel time. 1: Coast to Stop. 2: Fast-stop using the time set in C1-09. 3: Alarm Only. Drive continues running, but displays an alarm. 4: Reduced Speed Operation. Drive continues to run with reduced frequency reference as specified in L8-19. Settings 0 through 2 trigger a fault relay if the heatsink becomes too hot.
0 to 4 3 A A A 4AF — L8-05 Input Phase Loss Protection Selection Selects the detection of input current phase loss, power supply voltage imbalance, or main circuit electrolytic capacitor deterioration. 0: Disabled 1: Enabled 0,1 1 A A A 4B1 — L8-07 Output Phase Loss Protection Selects the output phase loss detection. 0: Disabled 1: Enabled (triggered by a single phase loss). 2: Enabled (triggered when two phases are lost).Output phase loss is detected when operating with less than 5% of the drive rated current. Detection can mistakenly occur if the motor is too small relative to the drive capacity rating (this parameter should be disabled in such cases).
0 to 2 1 A A A 4B3 — L8-09 Output Ground Fault Detection Selection Selects the output ground fault detection. 0: Disabled 1: Enabled 0,1 A A A 4B5 — L8-10 Heatsink Cooling Fan Operation Selection Controls the heatsink cooling fan operation. 0: Fan On-Run Mode - Fan will operate only when the drive is running and for L8-11 seconds after stop. 1: Fan always on - Cooling fan operates whenever the drive is powered up. 0,1 0 A A A 4B6 — L8-11 Heatsink Cooling Fan Operation Delay Time This parameter sets the delay time for the cooling fan to shut off after the run command is removed when L8-10 = 0. 0 to 300 60 s A A A 4B7 — L8-12 Ambient Temperature Setting Used to input the ambient temperature.
This value adjusts the drives OL2 detection level. -10 to 50 40 °C A A A 4B8 —