omron — U: Monitors

B.2 Parameter Table Default setting value is dependent on parameter o2-04, Drive Unit Selection. Values shown here are for 200 V class drives. Double the value when using a 400 V class drive. The available tuning methods depend on control mode. Select values 2 or 3 in V/f control, 0 or 2 in OLV control, and 2 for Motor 2 control. ◆ U: Monitors Monitor parameters allow the user to view drive status, fault information, and other information about drive operation. 360 OYMC TOEP C71060622-01-OY V1000 User Manual No. Name Description Range Def. Control Mode Addr. Hex Pg. V/f O LV P M T1-05 Motor Base Frequency Sets the base frequency of the motor in Hertz (Hz).

0.0 to 400.0 60.0 Hz A A − 705 — T1-06 Number of Motor Poles Sets the number of motor poles. 2 to 48 4 A A − 706 — T1-07 Motor Base Speed Sets the base speed of the motor in revolutions per minute r/min (RPM). 0 to 24000 1750 r/min A A − 707 — T1-11 Motor Iron Loss Provides the iron loss for determining the Energy Saving coefficient. The value set to E2-10 (motor iron loss) when the power is cycled. If T1-02 is changed, an initial value valid for the selected capacity will be shown. 0 to 65535 14W A − − 70B — These values differ depending on the motor code value and motor parameter settings. No. Name Description Analog Output Level Unit Control Mode Addr. Hex V/f O LV P M U1:

Operation Status Monitors Use U1 monitors to display the operation status of the drive. U1-01 Frequency Reference Monitors the frequency 10 V: Max frequency 0.01 Hz A A A 40 U1-02 Output Frequency Displays the output voltage. Display units are determined by o1-03. 10 V: Max frequency 0.01 Hz A A A 41 U1-03 Output Current Displays the output current. 10 V: Drive rated current 0.01 A A A A 42 U1-04 Control Mode Control method set in A1-02. 0: V/f without PG 2: Open Loop Vector (OLV) 5: PM Open Loop Vector (PM) No output signal available – A A A 43