omron — IP20/NEMA Type 1

3.5 Protective Covers Figure 3.11 Figure 3.11 Remove the Conduit Bracket on an IP20/Open-Chassis Drive ■ Reattaching the Protective Covers Pass power wiring and control signal wiring through the exit holes on the bottom of the conduit bracket of the drive. Place power wiring and control signal wiring in separate conduits. Properly connect all wiring after installing the drive and connecting other devices. Reattach all protective covers when wiring is complete. Figure 3.12 A A – Pass power wiring and control signal wiring through different exit holes at the bottom of the drive.

Figure 3.12 Reattach the Protective Covers and Conduit Bracket on an IP20/NEMA Type 1 Drive 58 OYMC TOEP C71060622-01-OY V1000 User Manual A