omron — 3.12 Wiring Checklist

3.12 Wiring Checklist 3.12 Wiring Checklist 80 OYMC TOEP C71060622-01-OY V1000 User Manual No. Item Page Drive, peripherals, option cards 1 Check drive model number to ensure receipt of correct model. 25 2 Check for correct braking resistors, DC reactors, noise filters, and other peripheral devices. 78 3 Check for correct option card model. 274 Installation area and physical setup 4 Ensure area surrounding the drive complies with specifications. 39 Power supply voltage, output voltage 5 The voltage from the power supply should fall within the input voltage specification range of the drive. 133 6 The voltage rating for the motor should match the drive output specifications.

25 118 Main circuit wiring 7 Confirm proper branch circuit protection exists per National and Local codes. 51 8 Properly wire the power supply to drive terminals R/L1, S/L2 and T/L3. 54 9 Properly wire the drive and motor together. The motor lines and drive output terminals R/T1, V/T2 and W/T3 should match in order to produce the desired phase order. If the phase order is incorrect, the drive will rotate in the opposite direction. 62 10 Use 600 Vac vinyl-sheathed wire for the power supply and motor lines. 59 11 Use the correct wire gauges for the main circuit. Refer to Table 3.2, Table 3.3, or Table 3.4. 59 • When using comparatively long motor cable, calculate the amount of voltage drop.

Motor rated voltage (V) x 0.02 ≥ 3 x voltage resistance (Ω/km) x cable length (m) xmotor rated current (A) x10 -3 59 • If the cable between the drive and motor exceeds 100 m, adjust the carrier frequency (C6-02) accordingly. 63 131 12 Properly ground the drive. Review page 63. 63 13 Tightly fasten all terminal screws (control circuit terminals, grounding terminals). Refer to Table 3.2, Table 3.3 or Table 3.4. 59