omron — Navigating the Drive and Programming Modes

4.3 The Drive and Programming Mode ■ Programming Mode Details The following actions are possible in the programming mode: • Verify Function: Verify parameter setting changes from original default values. • Setup Group: Access a list of commonly used parameters to simplify setup. • Parameter Setting Mode: Access and edit all parameter settings. • Auto-Tuning: Automatically calculates and sets motor parameters for Open Loop or PM Vector control to optimize the drive for the motor characteristics. The Setup Group within the Programming Mode In Setup Group, the user can access the minimum group of parameters required to operate the application. Start-Up Programming & Operation Note:

Setup Group parameters are listed in Appendix B, and indicated with the letter “S” in the Access Level column. Note: Pressing ENTER from APPL navigates to the Application Preset setting display. When the set value is changed, the parameter is changed to the optimum value for each application. It is set to 0 (General-purpose) prior to shipment. Refer to Application Presets on page 107 . Figure 4.5 illustrates the keys to press to enter the Setup Group. In this example, the source of the frequency reference is changed from the control circuit terminals to the LED Operator (i.e., b1-01 is changed from 1 to 0).

4 Figure 4.5 y appears when powered up  STOP Press until appears  Parameter Display Control Circuit Terminal Select digit to edit  Parameter Display LED Operator *1 Pressing ENTER from APPL navigates to the Application Preset setting display. When the set value is changed, the parameter is changed to the optimum value for each application. It is set to 0 (General-purpose) prior to shipment. *2 Move to the right to change parameter settings. Scroll down to view and check settings in the Setup Mode *3 To return to the Top Menu, press . To view or edit other parameters, Figure 4.5 Setup Group Example press and . OYMC TOEP C71060622-01-OY V1000 User Manual 97