User's Guide Solving Problems Related Information & “Contacting Epson Support” on page 208 & “Installing the Optional Units” on page 194 & “Replacing Maintenance Rollers in Paper Cassette 1” on page 120 & “Replacing Maintenance Rollers in Paper Cassette 2 to 4” on page 124 & “Installing Applications” on page 149 & “Updating Applications and Firmware” on page 149 Error Code on the Status Menu If a job does not complete successfully, check the error code displayed on the history of each job. You can check the error code by pressing the button, and then selecting Job History . See the following table to find the problem and its solution.
152 Error Messages Solutions Failed to receive faxes because the fax data capacity is full. Press [i] for details. Received faxes may accumulate without being processed due to the following reasons. ❏ Cannot print because a printer error has occurred. Clear the printer error. To check the details and solutions to the error, press the button and then select Printer Information. ❏ Cannot save in the computer or the memory device. To check whether or not received faxes have been saved, press the button and then select Job Monitor > Communication Job. To save received faxes, turn on the computer or connect a memory device to the printer.
Combination of the IP address and the subnet mask is invalid. See your documentation. See the Network Guide. Recovery Mode The printer has started in recovery mode because the frimware update failed. Follow the steps below to try to update the frimware again. 1. Connect the computer and the printer with a USB cable. (During recovery mode, you cannot update the frimware over a network connection.) 2. Visit your local Epson website for further instructions. Code Problem Solution 001 The product was turned off by a power failure. - 106 Cannot print from the computer due to the access control settings. Contact your printer administrator. 107 User authentication failed. The job has been canceled.
❏ Make sure that the user name and password are correct. ❏ Select Setup > System Administration > Security Settings > Access Control. Enable the user restriction function, and then allow the job without an authentication information.