User's Guide Solving Problems 153 Code Problem Solution 108 Confidential job data was deleted when the product was turned off. - 109 The received fax was already deleted. - 110 The job was printed on one side only because the paper loaded does not support double sided printing. If you want to perform 2-sided printing, load paper that supports 2-sided printing. 201 The memory is full. ❏ Print received faxes from Job Monitor in Job Storage. ❏ Delete received faxes saved in the inbox from Job Storage in Status Menu. ❏ If you are sending a monochrome fax to a single destination, you can send it by using Direct Send. ❏ Divide your originals in two or more to send them in several batches.
202 The line was disconnected by the recipient machine. Wait for a while and then try again. 203 The product cannot detect the dial tone. ❏ Make sure that the phone cable is connected correctly and the phone line is working. ❏ When the printer is connected to the PBX or the terminal adapter, change the Line Type setting to PBX. ❏ Select Setup > System Administration > Fax Settings > Basic Settings > Dial Tone Detection, and then disable the dial tone setting. 204 The recipient machine is busy. Wait for a while and then try again. 205 The recipient machine does not answer. Wait for a while and then try again. 206 The phone cable is incorrectly connected to the LINE and EXT.
port of the product. Check the connection of the LINE port and the EXT. port of the printer. 207 The product is not connected to the phone line. Connect the phone cable to the phone line. 208 The fax could not be sent to some of the specified recipients. Print a Fax Log or Last Transmission report for previous faxes from Fax Report in the Fax mode to check the failed destination. When the Save Failure Data setting is enabled, you can resend a fax from Job Monitor in Status Menu. 301 There is not enough storage space available to save the data in the memory device. ❏ Increase the storage space in the memory device. ❏ Reduce the number of documents.
❏ Lower the scanning resolution or increase the compression ratio to reduce the size of the scanned image. 302 The memory device is write-protected. Disable write protection on the memory device. 303 No folder has been created to save the scanned image. Insert another memory device. 304 The memory device has been removed. Reinsert the memory device.