ZMM-Sliven C8C CU 325 — ZMM-Sliven C8C CU 325 Universal Lathe Machine Manual PDF

3.5 MACHINE POSITIONING, FOUNDATION AND LEVELING To maintain the guaranteed machine accuracy it is of great importance to install and accurately level the machine on its foundation place. 3.5.1 FOUNDATION The foundation is to be made by concrete in compliance with machine foundation layout Fig. 3-3 or Fig. 3-4. Outside dotted line denotes machine-working area necessary for operation and service. The foundation concrete thickness is recommended not less tan 350 mm. The anchoring/foundation bolts holes in the foundation shall be 80х80х350 mm.

When the machine is to be installed on area where shock and vibrations sources exist it should be necessary to insulate the foundation by an anti vibration material. 3.5.2 INSTALLATION AND LEVELING When the concrete is compactly hardened install and level the machine as following: Place the levelling plates close to foundation holes so that when positioning the machine on place its levelling bolts step on the plates, and the foundation bolts go into the foundation holes. At this position place a level gauge of an accuracy 0,02/1000mm. By the levelling bolts make an initial machine levelling in compliance with Check No.1, DIN 8606 (Refer to section 8 “Protocol for geometric accuracy”.

Then prepare a concrete mixture 1:3 (cement: sand) and fill the foundation holes up and also fill up entire gap between foundation surface and machine feet so that the machine step firmly on the foundation. When the concrete is compactly hardened uniformly tighten foundation bolt nuts. Check the machine levelling again and adjust if necessary. The machine may be alternatively installed directly on an enough rigid concrete floor. Levelling plates are placed directly on the floor and the machine levelling bolts step on them. Then the levelling procedure is made as describe above.

This method shows satisfactory machining accuracy and it is preferable when the machine is to be often displaced from one place to another. C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 19/67