Verify if the machine electrical specification comply to the mains; Connect the machine via fast acting disconnector following the specifications in the “Shipping documents E100” attached to this manual. The power supply cable section must comply with machine power and distance to local electric cabinet following the specifications in the “Shipping documents E100” attached to this manual. Protect the power supply cable at machine entrance by hard cable duct (pipe). Ensure correct machine ground. This is valid for mains of direct grounded star- center.
For countries where the electric supply nets are low voltage net and isolated-star center the machine must be ground in compliance with the national standards. Connection to ground or neutral for nets of having isolated star-center is made using the input ground/neutral bar where the input ground/neutral wire is to be connected. Before switching the supply on provide check of all electric components condition as electric cabinet, controls, terminal connections etc. and tighten if necessary. After switching the power on check to verify the lack of dangerous electric potentials of the machine to ground.
Execute several tests with machine electrical controls to verify the correct function in compliance with section 3.7. 3.7 VERIFICATION THE FUNCTION OF MACHINE ELECTRIC CONTROLS AFTER CONNECTION Very important: This machine is delivered to you without oil in gearbox, feed box and apron. Before electric components verification it is necessary these boxes to be fill up by oil and also lubricate respective machine parts in compliance with the instructions under section 5 of this manual. Execute verification of the electric controls function (refer to machine electric diagram ) as following: Turn the main power switch QSO on position “I”.
Indicator HL on the control panel goes on indicating electric cabinet live. Start the main drive motor by pushbutton SB1 and stop it by pushbutton SB0.1 Verify the function of the coolant pump motor by ON/OFF SB2. Verify work light by switch SB4. 3.8 MACHINE START UP When start up the machine after installation or after long time being shut down it is necessary to verify machine lubrication condition. Also the machine must be cleaned after long time being shut down. Check the oil level in gearbox, feed box and apron as well as piston oil pump oil box. Lubricate bed slide ways, carriage slides, lead screw and tailstock. Machine start up procedure: Manually move the machine movable parts.
The parts should move smooth without any resistance; C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 21/67