ZMM-Sliven C8C CU 325 — ZMM-Sliven C8C CU 325 Universal Lathe Machine Manual PDF

The coolant system serves to cool the cutting area and the cutting tool by splashing coolant liquid. The coolant pump 1 deliver the coolant liquid from coolant tank 2 through hose 3 to a flexible pipe mounted on the carriage. By a tap 4 on the pipe the coolant flow rate can be adjust. Used coolant liquid directly flows back to coolant tank 2 from coolant basin 5. An on/off switch on the control panel controls the coolant pump motor. It is recommended to switch off the coolant pump motor when tap 4 is closed. Before and after operation with the coolant system clean and lubricate unpainted machine surfaces that may be attacked by a splashing liquid. Allays use coolant that is not corrosive.

When the coolant system fail to deliver liquid or the flow rate decrease the cause must be found and eliminated. Mostly, the cause is non-following regular cleaning of the coolant system. When often operate with coolant system it is recommended cleaning the system at least once per 6-months. Also clean the coolant tank once per week and exercise regular analyse of the coolant liquid properties. The selection of coolants shall be in compliance with the cutting conditions, material under machining and be safety for the operator. Washing hands by coolant not admitted . Fig.4-15 C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 34/67