6.2.10.ADJUSTMENT THE MAIN DRIVE V-BELTS TENSION (SEE FIG.6-13) The tension of main drive V-belts are factory adjusted. However, after machine start up and after several hours of operation it is recommended to check the V-belts tension and adjust if necessary. V-belts tension adjustment also required after V-belts change. It is recommended to verify the V-belts tension in a month time machine operation and adjust if necessary. Warning: Please, have in mind that if one only belt is found damage the full set must be change. The new V-belts are mount on the V-belt pulleys manually . Do not use tools that may damage the V-belts. F e =100-150N f=L f /100 6мм Fig.6-13.
Adjustment the main drive V-belts tension Procedure Remove the lid from machine foot under the gearbox to access the V-belts; Slightly loose bolts 2 fixing the motor mounting plate; Adjust the V-belts tension by tighten screw 1; Warning: Do not over tight the V-belts. Any V-belts over tight leads to fast wear out of them, overload of motor and gearbox input shaft bearings. After adjustment the V-belts correct tension tighten bolts 2 to fix the motor mounting plate. When start the machine at high speed verify that no V-belts slippage occurs or generation of strange noise. Verification of the adjustment C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 53/67