ZMM-Sliven C8C CU 325 — ZMM-Sliven C8C CU 325 Universal Lathe Machine Manual PDF

8.2 GEOMETRICAL TESTINGS C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 57/67 Variations No Object of testing Diagr am T est apparatus Test instructions permissible measured G1 Straightness of carriage movement in the horizontal plane or in the plane defined by the axis of the centers and the tool point а) L up to 1500mm Dial indicator according to DIN 879. Test mandrel or straightedge 300 up to 500mm long b) for any turning length Test wire and microscope or optical methods а) Mount test mandrel between centers, Dial indicator on carriage. Stylus bearing in the horizontal plane against the test mandrel. Traverse carriage along the test mandrel.

b)-Attach test wire at tailstock, pass it over a pulley at the end of the bed and tension with a weight. Microscope on carriage. Line up the test wire at c and d by means of cross wires of the microscope. Traverse carriage along the wire а) and b) 0.015mm L up to 500mm 0.02mm L over 500mm up to 1000mm If the turning length exceeds 1000mm, the permissible variation is to be increased by 0.005mm for each additional 1000mm, but without exceeding 0.03mm а) ........mm b).........mm G2 Parallelism of carriage movement and tailstock guides а) in the horizontal plane b) in the vertical plane Dial indicator according to DIN 879 Dial indicator on carriage; stylus in contact with tailstock quill.

The quill must be run out to a sufficient distance and locked as under normal working conditions. Traverse carriage and tailstock jointly over the full length of the bed. a) and b.) 0.03mm L up to 1500mm Local tolerance 0.02mm by 500mm а) and b) 0.04mm L over 500mm Local tolerance 0.03mm by 500mm а)........mm b).....…mm .......... mm ….......mm G3 а) Operating spindle axial run- outo b) Movement accuracy in relation to face plane Dial indicator according to DIN 879 (Auxiliary measurement aid) Dial indicator: а) on spindle axis b) on spindle face plane Slowly rotate spindle. In the event of play in the trust bearings, apply constant force F. The value of F is be specified by the manufacturer.

а) 0.01mm b) 0.02mm (including axial run- out) а)........mm b)....... mm G4 Run out of spindle nose centering taper Dial indicator according DIN 879. Apply the dial indicator at right angles to the circumference of the taper. Slowly rotate spindle. In the event of play in the trust bearings, apply constant force F. The value of F is be specified by the manufacturer. 0.01mm ....….mm G5 Run out of internal taper of spindle а) at spindle nose b) at a distance equal to half the maximum turning diameter, subject to maximum of 300mm Dial indicator according DIN 879. Test mandrel with mounting taper Test mandrel in internal taper. Apply dial indicator to circumference of test mandrel.

Rotate spindle. Measure at a, then at b. а)0.01mm b)0.0mm for a measuring length of 300m а)...... mm b).......mm G6 Parallelism of spindle axis with carriage movement over a length equal to half the maximum turning diameter, subject to a maximum of 300mm а) in the horizontal plane b) in the vertical plane Dial indicator according DIN 879. Test mandrel with mounting taper Test mandrel in the internal taper of spindle. Bring to mid- way position of run out. Bring stylus into contact with circumference of test mandrel. Traverse carriage through the test distance; sequence of measurement as for G5.

а) 0.015mm by 300mm directed towards tool point b) 0.02mm by 300mm directed upwards а) ......mm b) ......mm