8.3 PRACTICAL TESTINGS C:\Users\ELENA\Desktop\UL_C8C_325_ENG.doc 59/67 Object of M achining conditions and Variations No testing Diagram Test apparatus Test instructions permissible measured P1 Working accuracy on longitudinal turning a) Roundness b) Cylindricity d≥da/8 da : maximum turning diameter l=0.5 da In the absence of any special agreements the manufacturer will specify: Form of tools used, material for the test workpieces (cast iron or steel) also feed rate, depth of cut, cutting speed etc. Test workpiece is to be mounted overhung in a suitable chucking device and finish turned in a single setting.
Micrometer or clip with dial indicator according to DIN897 а) Two-point or three-point measurement. The largest diameter difference resulted is the amount of the variation. b) The difference in the two diameters turned is the amount of the variation. а) 0.01mm b) 0.04mm l= 300mm а).......mm b).......mm l=.......mm P2 Working accuracy on facing d≥0.5 da l= da/8 The workpiece to be mounted on a suitable chucking device. There are two or three circular planes. (one of them in the middle) that is to be faced in a single pass. Straightedge (of a suitable length in relation to diameter of the workpiece) and Slip gauge (clearance gouge).
Place straightedge on the faced surface of the test work piece , either direction or on two slip gauges of the same thickness. Determine distance between straightedge and test work piece by introducing slip gauges over the whole diameter. 0.025mm d=300mm The surface is allowed concave only. .......…mm d=…...…. Р3 Accuracy of pitch on thread cutting The pitch accuracy is verified by Geometrical test G3. Therefore the practical test P3 is carried out under special agreement, only . Work piece to be mounted between centers and is finish cut in a single setting. The thread may start at any point on the lead screw. Precision measuring instrument.
The test instructions can be specified according to the type of precision measuring instrument used by the manufacturer. 0.04mm by 300mm L up to 2000mm . Measured any place. Local tolerance: 0.015mm by 60mm Measured any place. . …….mm …….mm ..............