HOME 1.25 VALVE LASH LASH MEASUREMENT TOOL NAME PART NUMBER sm01737 CRANKSHAFT ROTATING WRENCH HD-45314 ANGLE BLADE FEELER GAUGE SET HD-47181 3 4 It is necessary to remove side covers from VRSCF models before proceeding. NOTE 2 1. Remove air box assembly. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 1 2. Remove starter solenoid from battery box. 3. Remove all clipped connectors from battery caddy. Discon- nect and remove starter solenoid. 1. IAC sensor connector [87B] 2. Idle air control (IAC) 3. Throttle position (TP) sensor connector [88B] 4. Injector intakes (covered) 4. Remove battery and tray components from motorcycle. a. Remove positive (4) and negative (13) battery cables.
Figure 1-64.Throttle Body Electrical Connectors b. Remove strap (1). c. Remove battery (6) from motorcycle. 5. See Figure 1-63 . Remove fuel lines. a. At the fuel rail, disconnect pressure fuel line and return fuel line by pressing release buttons with thumb and first finger. d. Remove left side battery caddy (5) and right side battery caddy (11). e. Remove fasteners (7) and (8) and remove battery tray (9) from motorcycle. b. Remove fittings at the fuel tank. c. Pull fuel lines away from the throttle body. sm01736 d. Remove ground wire from valve cover. 6. Remove front and rear coils. See 1.22 SPARK PLUGS AND COIL . 7. Disconnect idle air control (IAC) connector [87B] from throttle body. 8.
Disconnect throttle position (TP) sensor connector [88B] from throttle body. sm01186 Figure 1-63. Fuel Line Figure 1-65. Intake Clamps,Thr (typical) 2009 VRSC Serv ottle Body Removed ice: Maintenance 1-51