Before installation Exhaust air towards the rear: Pipe diameter: 100 mm ❑ Break off cover on the rear panel of the extractor hood; strike the retaining points with a tool. Circulating-air mode ❑ With activated carbon filter if exhaust-air mode is not possible. ❑ The air purified by an additional activated carbon filter is conveyed back into the room. ❑ For insertion of the activated carbon filter see Instructions for use. ❑ If the extractor hood is switched from exhaust-air mode to circulating-air mode, the exhaust-air opening must be sealed to prevent a hazardous situation (see optional accessories in the Instructions for use). To prevent damage to the fan, hold the tool vertically.
❑ Remove the broken off metal part (possibly a noisy and disruptive procedure). ❑ If the extractor hood has 2 motors, the opening on the plastic part must be made at the rear; cut through the 3 ribs and remove the cut-off part. Electrical connection WARNING: THIS APPLIANCE MUST BE EARTHED IMPORTANT: Fitting a Different Plug: The wires in the power cord are colour- coded as follows: Green and Yellow – Earth Blue – Neutral Brown – Live If you fit your own plug, the colours of these wires may not correspond with the identify- ing marks on the plug terminals. Proceed as follows: 1.
Connect the green and yellow (Earth) wire to the terminal in the plug marked ‘E’ or with the symbol ( ), or coloured green or green and yellow. 2. Connect the blue (Neutral) wire to the terminal in the plug marked ‘N’ or coloured black. ❑ Cut off the outer part of the exhaust-air ❑ Insert the inner part and turn as far as possible. 25 onnection.